Had a grand vision last week of converting my volca modular into a full on eurorack module by making a custom enclosure that fits in a case and then making a patchbay module that converts the jumper wire connections into full on patch cable jacks. My question here is if the cv/gate patch points on the clock section can be amplified from 0.5v/oct to full v/oct so that I can use the built in sequencer to sequence other eurorack gear, and at the same time if normal eurorack cv signals would need to be attenuated when going rack -> volca so that I don't fry this thing. Not sure if there's information I'm missing or if I'm not understanding something but from my layman's perspective all I would need to do is amplify outgoing signals and attenuate incoming signals to translate between the different working voltages of each system.
[link] [comments]