+- Vortex Sound Research (http://www.n01ze.com/synthwizards/Forum)
+-- Forum: N01ZE World Net News (http://www.n01ze.com/synthwizards/Forum/forumdisplay.php?fid=45)
+--- Forum: World Wide Gear News (http://www.n01ze.com/synthwizards/Forum/forumdisplay.php?fid=2)
+--- Thread: Just picked up a MS-101 - a few questions (/showthread.php?tid=3648)
Just picked up a MS-101 - a few questions - SynthWizard - 09-09-2019
Just picked up a MS-101 - a few questions
<!-- SC_OFF --><div class="md"><p>Hey - as the title says, I just picked up a MS-101 and I was hoping someone might be able to chime in with some help.</p> <ol> <li><p>I downloaded the Behringer SynthTool v1.3.1 (Windows 10) from the Behringer site, and I’m trying to update the firmware. The MS-101 is connected and detected by the software, however I keep getting the error message “Failed, check network and press to retry”. The network is fine and I’ve even tried completely turning off the firewall, to no avail. </p></li> <li><p>The SynthTool software states “Current Version: 1.1.2” however it is unclear if this means the currently installed firmware or the most current version that is available. This, of course, might be the cause of the issue described in #1 - but it’s very unclear. </p></li> <li><p>Only the left channel is output over the Output jack, in the Phone jack both channels are audible. Is there a setting I need to adjust or is the Output jack not functioning properly? </p></li> </ol> <p>Any help is appreciated, I’m new to all this
</p> </div><!-- SC_ON --> submitted by <a href="https://www.reddit.com/user/Synthsarefun"> /u/Synthsarefun </a> <br/> <span><a href="https://www.reddit.com/r/synthesizers/comments/d1vu4y/just_picked_up_a_ms101_a_few_questions/">[link]</a></span> <span><a href="https://www.reddit.com/r/synthesizers/comments/d1vu4y/just_picked_up_a_ms101_a_few_questions/">[comments]</a></span>