What’s your “hardware table” setup like? I’m mapping mine out.

[SynthWizard]

0			0

What’s your “hardware table” setup like? I’m mapping mine out.

I have a new studio space. It’s roughly 7 feet wide by 10 feet deep and is shaped like a hallway.

So far I have put my studio desk at the end of the hall and now have some space running down the side walls. Fairly typical studio setup. I have space for a long table to put my hardware on and am mapping out how I want to do it.

I have a desktop rack and was thinking about getting a patch bay and putting it at the top of the rack with a PSU racked under. That would leave space for some gear to slide under. Was thinking I’d patch my gear into the bay and run a snake from the patch bay to my interfaces at the studio desk. The PSU can power everything.

Posting this because in my head it seems to make sense but I’d like to hear if I am missing anything obvious (I tend to do that in my studio setups at times). Also was interested in any of you all who have a similar layout and how you route your gear. What tables you all use as well (Id like something fairly sturdy, some of the IKEA stuff can wobble on me).

gear - DFAM, TR8S., Boog, Palette modular case, BS2

submitted by /u/itssexitime
[link] [comments]