| 0 | 0 | ||
Hello again my friends. I'm the guy last week or so who was concerned with heat buildup in his modular case. You all have been massively helpful and since then I have done some drilling and installed two fans in my wooden case....
Now that I have confidently installed my last "nail in the coffin" module and fired it on for the first time as a complete system, I'm noticing a different problem. When I flicked the switch, the modules would all flash on and off followed by a loud click through my headphones. To me at first it looked like a short, but what I tried next was removing the new neutron and power cycling again. Worked perfectly. After the Power was on, I plugged the new neutron in again... Worked perfectly.
My deduction is that the power supply is overloaded now upon startup, but can handle the normal operation after the initial spike. My question now becomes this: Is there a way to sort of delay the powering on of one busboard or just that neutron?
I have come this far and refuse to be defeated! For reference here is my completed case. I have built all of them myself sans the neutrons obv. Preferably I would like this solution not to take up any hp because honestly I'm fresh out. Thank You!!!
[link] [comments]
![[-]](http://www.n01ze.com/synthwizards/Forum/images/Carbon/collapse.png "[-]")
