| 0 | 0 | ||
<!-- SC_OFF --><div class="md"><p>My Dreadbox Dysphonia's 12dB filter isn't working: the 3X signal ins pass sound thought to the HP out (but without the cut off/res working), a faint signal to BP (no cut/res) and nothing from LP.</p> <p>I've checked all the solder joints, no bridges, bad joints, misplaced components etc. Done a full calibration. Everything else is fine.</p> <p>I did apply heat to a resistor (R31)...the manual said to solder the top pin of the slider from above: small space and shaky hands! Could this be the issue, and if so, what value resistor would replace it?</p> <p>Many thanks!</p> </div><!-- SC_ON --> submitted by <a href="https://www.reddit.com/user/ioniansensei"> /u/ioniansensei </a> <br/> <span><a href="https://www.reddit.com/r/synthesizers/comments/rhjn1e/dreadbox_dysphonia/">[link]</a></span> <span><a href="https://www.reddit.com/r/synthesizers/comments/rhjn1e/dreadbox_dysphonia/">[comments]</a></span>
![[-]](http://www.n01ze.com/synthwizards/Forum/images/Carbon/collapse.png "[-]")
