| 0 | 0 | ||
<!-- SC_OFF --><div class="md"><p>Hello again my friends. I'm the guy last week or so who was concerned with heat buildup in his modular case. You all have been massively helpful and since then I have done some drilling and installed two fans in my wooden case....</p> <p>Now that I have confidently installed my last "nail in the coffin" module and fired it on for the first time as a complete system, I'm noticing a different problem. When I flicked the switch, the modules would all flash on and off followed by a loud click through my headphones. To me at first it looked like a short, but what I tried next was removing the new neutron and power cycling again. Worked perfectly. After the Power was on, I plugged the new neutron in again... Worked perfectly. </p> <p>My deduction is that the power supply is overloaded now upon startup, but can handle the normal operation after the initial spike. My question now becomes this: Is there a way to sort of delay the powering on of one busboard or just that neutron? </p> <p>I have come this far and refuse to be defeated! For reference here is my completed case. I have built all of them myself sans the neutrons obv. Preferably I would like this solution not to take up any hp because honestly I'm fresh out. Thank You!!!</p> <p>​</p> <p><a href="https://www.modulargrid.net/e/racks/view/731316">https://www.modulargrid.net/e/racks/view/731316</a></p> </div><!-- SC_ON --> submitted by <a href="https://www.reddit.com/user/mooseinbeesocks"> /u/mooseinbeesocks </a> <br/> <span><a href="https://www.reddit.com/r/modular/comments/d6fljp/power_cycling_issue_in_modular_case_halp/">[link]</a></span> <span><a href="https://www.reddit.com/r/modular/comments/d6fljp/power_cycling_issue_in_modular_case_halp/">[comments]</a></span>
![[-]](http://www.n01ze.com/synthwizards/Forum/images/Carbon/collapse.png "[-]")
