0 | 0 | ||
<!-- SC_OFF --><div class="md"><p>Hi. My keystep is upgraded to the latest firmware and the dipswitches are set to internal. I have factory reset it by holding down the octave buttons and plugging it in. </p> <p>In either SEQ or Arp mode, the play/pause button just blinks. </p> <p>I seem to be able to record a sequence but not play it. Arp does nothing, the tap button doesn't turn red like i've seen in videos. I can play single notes/chords just fine through Midi over USB or Midi over 5 pin. </p> <p>Does anyone have any ideas? Something in Midi control center? As far as I can remember, arp/seq hasn't ever worked but I wasn't concerned because I assumed I was just doing something wrong. Thanks.</p> </div><!-- SC_ON --> submitted by <a href="https://www.reddit.com/user/Time_Reverses"> /u/Time_Reverses </a> <br/> <span><a href="https://www.reddit.com/r/synthesizers/comments/x5vq4r/keystep_seq_and_arp_not_working_wsoft_or_hardware/">[link]</a></span> <span><a href="https://www.reddit.com/r/synthesizers/comments/x5vq4r/keystep_seq_and_arp_not_working_wsoft_or_hardware/">[comments]</a></span>