Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dreadbox Dysphonia
Staff
#1
0
0
Dreadbox Dysphonia

My Dreadbox Dysphonia's 12dB filter isn't working: the 3X signal ins pass sound thought to the HP out (but without the cut off/res working), a faint signal to BP (no cut/res) and nothing from LP.

I've checked all the solder joints, no bridges, bad joints, misplaced components etc. Done a full calibration. Everything else is fine.

I did apply heat to a resistor (R31)...the manual said to solder the top pin of the slider from above: small space and shaky hands! Could this be the issue, and if so, what value resistor would replace it?

Many thanks!

submitted by /u/ioniansensei
[link] [comments]
Reply


Forum Jump:

[-]
Private Messages
Please login or register to use this functionality.

[-]
Who's Online
There are currently no members online.

[-]
Latest Threads
Toy solar system adding line out - Harde...
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 108
NoiseWorks Audio launch Complete Bundle
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 110
Yamaha CK76 joins stage piano range
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 86
Sample Logic launch Quadra plug-in
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 92
UJAM release DETUNICORN
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 89
fedDSP launch ECO delay plug-in
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 98
Akai Pro release MPK Mini Plus II
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 93
Roland launch two new Boutique synths
Last Post: SynthWizard
10-31-2026 09:46 AM
» Replies: 0
» Views: 141
The TyCoon Synthesizer
Last Post: SynthWizard
10-31-2026 07:21 AM
» Replies: 0
» Views: 132