Does Neutron need its own unshared power zone in Behringer's 2x140 HP case?

[SynthWizard]

0			0

Does Neutron need its own unshared power zone in Behringer's 2x140 HP case?

The Behringer 2x140 HP manual, giving the example of mounting the Model-D, instructs the user to plug no other modules into the Zone powering that synth, even though the Model D's power requirements (580 +12) aren't particularly close to the power output to 1 zone (1 Amp). I'm guessing I should do so too with a Neutron, whose power requirements are higher? I was hoping to sneak in a low power module in that zone as well, just to get the most out of the case. Thanks for your tips.

submitted by /u/HazelnutEyedNym
[link] [comments]