| 0 | 0 | ||
My Dreadbox Dysphonia's 12dB filter isn't working: the 3X signal ins pass sound thought to the HP out (but without the cut off/res working), a faint signal to BP (no cut/res) and nothing from LP.
I've checked all the solder joints, no bridges, bad joints, misplaced components etc. Done a full calibration. Everything else is fine.
I did apply heat to a resistor (R31)...the manual said to solder the top pin of the slider from above: small space and shaky hands! Could this be the issue, and if so, what value resistor would replace it?
Many thanks!
[link] [comments]
![[-]](http://www.n01ze.com/synthwizards/Forum/images/Carbon/collapse.png "[-]")
