| 0 | 0 | ||
I just ordered a second unit (yay!) and decided to check out the "fixed tuning" ("bypass tuning knob" in the software, or some key-press toggles on the hardware). It's supposed to tune to the nearest C (MIDI).
It's almost a semitone flat...
If my second unit is equally flat, then it's fine, and I can tune other instruments to A420 (blaze?) instead of A440. If the second unit is some other number, that's annoying asf.
Anyone else run into this? Of course I can tune manually, and I swapped the knobs so I don't accidentally bump the tune controls as much, but to keep 4 of them lined up? I've got concerns...
Mostly worried about Paraphonic mode, so I guess I was rather hoping one oscillator could be locked to the tuning of the other (one master tune knob) or a master tune knob on the back or internal trim pot.
The only "calibration" guides I saw in the manual were for "assign out" and for "delay clock" so I called SweetWater and they said to call Behringer. Figured I'd ask here first, you guys are more helpful!
[link] [comments]
![[-]](http://www.n01ze.com/synthwizards/Forum/images/Carbon/collapse.png "[-]")
