Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Juno 106 Dead Key Issue
Staff
#1
0
0
Juno 106 Dead Key Issue

Hello All!

I've recently began repairs on my Juno 106 and have run into some issues regarding a few keys that will not trigger. Ive done the voice chip diagnostic and all 6 seem operational. The keys in question are all the same (E, C, Ab, E, C, Ab, starting from the bottom up). I've cleaned the physical contacts on them all but they still do not register in the diagnostic mode or trigger any noise form the synth. All of the diodes on the physical keyboard are all within tolerance as well. I've also plugged in a separate MIDI keyboard controller and the keys in question do work! I believe it is some sort of internal MIDI encoding issue from the internal keyboard itself? Thank you for any help or insights as I've been stuck for a couple months on this one!

All my best!

submitted by /u/MrQuicksilver77
[link] [comments]
Reply


Forum Jump:

[-]
Private Messages
Please login or register to use this functionality.

[-]
Who's Online
There are currently no members online.

[-]
Latest Threads
My Forever Studio: Chromeo’s subterranea...
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 2
Synth Deals from Korg, Elektron and Inte...
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 2
Zynaptiq announces Morph 3 and Morph 3 P...
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 2
Deal: 30% off Steinberg Cubase 13!
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 2
Tasty Chips GR-MEGA: New Video and a Shi...
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 3
Hit’n’Mix RipX DAW updated
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 2
Aodyo Instruments launch Loom Kickstarte...
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 2
Pulsar Audio unveil Primavera spring rev...
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 2
Orange Clip by Schwabe Digital
Last Post: SynthWizard
Yesterday 11:38 AM
» Replies: 0
» Views: 3